![]() Select I accept the agreement to agree to the licensing terms, and click Next.Click N ext on the initial Welcome and Setup Wizard screens.Run the KillDisk-Ultimate-Setup.exe file downloaded from the U-M DropBox folder.Download the U-M licensed version of Killdisk from the U-M DropBox location.Download and Installįollow these instructions using a Windows computer with Intel Pentium or higher, 1 GB of RAM, Video VGA resolution 800 x 600 or better, and Windows 7 or higher. This must include using the fingerprint option, and/or generating a Certificate of Destruction to be attached to the device as verification that KillDisk was run on that device. Important! To avoid charges when devices or storage media are turned over to Property Disposition for disposal or resale, you must erase your device using KillDisk by following the instructions below. It also meets the Information Assurance requirements for erasing solid state drives (SSDs). This process can be used on computers running Windows or Unix/Linux, and most device types using those systems. See Securely Dispose of U-M Data and Devices for more information on securely disposing of data and devices, including other device types. Use of KillDisk following these instructions will satisfactorily prepare devices for resale or disposal by U-M Property Disposition, and complies with university policies and standards for securely disposing of data and devices. See Erase Personal Devices Before Disposal for information on ways to meet this requirement and also protect your personal data and privacy. Important! You are required to properly dispose of personal devices that have been used to work with or store U-M data. This copy may be used at no cost for an unlimited number of uses on U-M owned devices. This document provides instructions for downloading, installing, registering, and using the U-M licensed copy of KillDisk. U-M has a license for its use by faculty, staff, and departments for U-M owned computers on all U-M campuses, including Michigan Medicine. ![]() Alternatively, go to Settings → Change PC settings → Update and Recovery → Recovery → Advanced Startup: Restart now, and then upon restarting go to Troubleshoot → Advanced Options: UEFI Firmware Settings.KillDisk can completely and securely destroy all data on hard drives, removable disks, and flash media devices, without the possibility of future recovery. To access the BIOS settings from Windows, hold the key while selecting Restart and go to Troubleshoot → Advanced Options: UEFI Firmware Settings. The manual that came with your motherboard can provide further clues, or you can try exploring all the sub-menus of the BIOS yourself. Some keyboards may require holding down the key too. Typical keys for entering the boot selection screen are, ,, or. You can refer to University of Wisconsin Division of Information Technology's knowledge base page for your particular manufacturer's board on how to enter the BIOS settings on various motherboards during boot. Since there's no consistency between motherboard manufacturers, no step-by-step instructions can be provided. ![]() However, sometimes Legacy (or MBR as it's sometimes referred to) is the only option, depending on the motherboard. If this is the case and you only see a blank screen, it is instead a display issue.īatocera should boot fine with UEFI, if that option appears you should select that. The SSH server is live and it is possible to log into it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |